About 2 hours continuous playtime when fully charged
Format
AVI
Pixels
640*480
Frame rate
20-30 FPS
Supports
video and voice recording function
Operating System
Windows XP/VISTA or above
IICharge
1. This DVR watch with built-in
chargeable lithium battery. Please connect the USB cable to watch with
the charger or connect to the USB port
of PC. After then it can
find the LED blinking. When the battery be fully charged, the LED will be on,
then charge should be stopped.
2. During recording, the watch may be turn
off automatically if the battery is low. However the recorded file can be
stored before the power turn off.
Standby modepress the “ON” button, Blinks
3 times, then start recording. LED light flashes three seconds after entering the video state.
3.Turn off
During recording, press and hold
“ON” button to save the recording file and then it will be turned off. (The LED
will blink for 3 times)
4.Photo
Standby mode,
press “PHOTO”button, like a photo shoot, LED light flashes
once.
5.Reset
Please press “PHOTO”+“ON” button to
restart.
6.Set date
①In the text file format
settings routinely: 2009-04-18 10:18:00, documents saved as: time, and kept
under the watch of the document root disk. Time will automatically run.
②Or the use of tools "Write
Time", run the software "Write Time" watch through the USB
computer connectivity, the system drive to find watches, and then point
"update" again "exit" pull out the USB plus, and reboot the
DVR watch system update time.
NOTE: 1) If the memory space not enough, the watch may stop and turn off
automatically.
2) When Video process, press the "ON" button,
the LED flashes 3 times.
3) “Press
and hold” means press the key for more than 3 seconds, and “Press” means press
once the key or less than 2 second.
IVConnect to computer
1. When the watch to be connected correctly, it can
be used as a moveable disk.
2. Camera driver installation
will be Add CD drive attached, the camera driver installed to your computer.
3. camera functions:
Watch the camera shut down the state, Press and hold "ON" button and
insert the USB cable to connect the watch with the computer, right after the
LED flashes to connect, and you have installed the driver, you will be in the
"My Computer "find" Standard Camera "of the equipment, at
this time you'll be able to drive as the camera used.
4. Remove USB drive.
a. Double click on the icon “Safety deletes the hardware” (the green arrow
under right of screen)
b. Click “stop” in the dialog of “Safety deletes the hardware”.
c. Choose the drive you need to stop, select “confirm”, the drive will
be deleted safely.
(The arrow space will jump out message: “’USB Mass Storage Device’ this
drive can safety pull out of the system”)
d. Close dialog “Safety delete hardware”.
e. Pull
out the drive & Disconnect of the computer.
VProblem solution
Trouble
description
Cause
analysis
Trouble
Shooting
No open
Procedure error
Press “reset” button
Disk full, no storage space
Deleted some documents /files
Or other Recording
Without electricity
To charge
No icon symbol
Main Board BIOS USB function closured
Enter CMOS to open USB function
USB cable is not inserted properly or access to
undesirable